01 Wolf service
Range Repair
Dual fuel and all-gas Wolf ranges — sealed burners, spark ignition, the oven cavity beneath them, and the griddle and charbroiler modules on the wider tops.
What people describe on the phone
- A burner clicks and clicks but never lights, and the clicking carries on after the neighbouring burners are already lit
- The oven half of a dual fuel range settles forty degrees below whatever the dial is set to
- The spark igniter keeps firing after the burner has caught, so the flame sits under a constant tick
- The integrated griddle or charbroiler no longer comes up to temperature, or heats unevenly end to end
How the visit goes
The appliance is opened, the rating plate read, and the circuit or component in question tested against the service documentation for that model and serial. You get told what is actually wrong and what the part costs before anything is ordered. If the honest answer is that the repair is not worth it, you get that answer too. What the visit and the work come to is set out in full below.
Prices Repair bands
What it costs once we know what it is
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
- Igniter or spark module $170–$450
- Burner valve or orifice service $230–$580
- Oven thermostat or sensor calibration $190–$420
- Convection fan or motor $260–$650
- Control board or touch panel $470–$830
- Door hinge, glass or seal $300–$660
Each line is a range because which part turns out to be at fault decides where inside it a job lands, and that is settled by the diagnosis rather than over the phone. Once it is settled you are given one figure covering parts and labour, you agree to it before any work starts, and the $89 you have already paid for the visit comes off it. Nothing is ordered until you have said yes, and the number does not move afterwards.
Set against that, a comparable professional range, before installation and ventilation work, costs $8,220–$16,970. On this island the appliance is usually set into millwork built around it, so replacing one is rarely only the cost of the appliance.
ReviewsMercer Island, WA
In their words
4.9 / 5 · 810 reviews
Our range sits in a tight galley run and I assumed nobody could reach behind it. He drew it out on the slack in the gas line, found a failed igniter switch, and had it lit again that afternoon.
Philippa V. · Town Center · Feb 2026
Griddle module on the wide top stopped coming up to heat at one end. He tested it against the service documentation, replaced a single element, and cleaned up better than he found it.
Rufus T. · The Lakes · Jul 2025
A 48-inch range that had to come out over a limestone floor. The floor was covered before anything moved, the range went back dead level, and the anti-tip bracket was checked in front of me.
Peter C. · East Seattle · Sep 2025