Wolf Appliance Service Mercer Island · WA

Cost Mercer Island, WA

Cost of Wolf Dual Fuel Range Repair

Four published bands cover the gas top and the oven's sensor and control; elements and the over-temperature protection are priced once measured.

Stainless gas range in grey-brown cabinetry, one burner cap off to show the brass fitting beneath, oven door down and a rack on the floor tiles
Burner base exposed, cavity empty, rack on the floor Reference frame
Cost of Wolf Dual Fuel Range Repair: ranges from the published bands of Mercer Island Wolf Appliance Repair, (206) 785-2960. Every job is priced in writing before work starts.
Work Where it turns up Range
Igniter or spark module gas burners on dual fuel and all-gas tops $170–$450
Burner valve or orifice service gas burners, especially at a low simmer $230–$580
Oven thermostat or sensor calibration range ovens and built-in wall ovens $190–$420
Control board or touch panel ovens, steam and speed ovens, drawers $470–$830
Bake or broil element no published band Quoted after the diagnosis
Over-temperature protection on the oven side no published band Quoted after the diagnosis

One flat $89 visit pays for the trip out and the whole diagnosis, and the $89 is deducted from the repair if you approve it.

Which half, then which part

A dual fuel range is priced one side at a time. The burners on top run on gas and a spark, the oven below runs on its own 240-volt circuit, and a fault normally belongs to one of the two. So the visit first settles which side the figure is for, and then which part on that side. Four kinds of work on this range have the published bands in the table; two more are quoted once the part is measured.

The gas top

Two bands belong to the burners. The igniter band covers the spark electrodes and the modules that fire them: the parts behind a burner that clicks without lighting, or keeps sparking after it has caught. The valve and orifice band covers the parts that meter the gas, the valve behind each knob and the orifice it feeds, which decide whether a burner holds a steady low simmer. On the current ranges the flame moves to a second, smaller tier of the burner at the simmer settings, so both tiers are checked under that band.

The pipework and the shut-off valve behind the range are a gas fitter’s work, not a range repair, and we do not price them.

The oven below

The other two bands belong to the electric oven. The sensor band covers the temperature sensor and its calibration, for an oven that heats but misses its setting. The control band covers the oven’s electronic control and touch panel.

Elements are quoted after the diagnosis. A dual fuel oven carries several, bake, broil and convection, and which one fits depends on the model and serial, so the price is set from that part number. The oven’s over-temperature protection is quoted the same way. The 240-volt supply that feeds the range is house wiring; when the fault is there, the readings go to an electrician.

How the $89 comes off

The visit is $89 and covers opening the range and measuring the half that failed. Approve the written figure and the $89 is taken off it; decide against the repair and the $89 is all you pay. Mercer Island Wolf Appliance Repair, (206) 785-2960.

ReviewsMercer Island, WA

In their words

5.0 / 5 · 539 reviews

  • One sealed burner burned yellow and left soot under every pan. He cleaned and reset the orifice, checked the others while he was in there, and the flame has been blue since.

    Hugo L. · Town Center · May 2026

  • Front left burner clicked non-stop for weeks and two other companies quoted a whole new burner assembly. It was the spark module. He showed me the meter reading and replaced the one part.

    Marianne K. · East Seattle · May 2026

  • Blower stuck on one speed and the light bank kept flickering. Two separate faults, both explained, both fixed in the visit. He also pointed out a duct problem that was not his to fix.

    Jonathan B. · North End · Jan 2026